Electroless Nickel Plating and Composite Plating
For Ferrous Metals, Copper & Aluminum Alloys

Critical Processing Factors For Series 200 Coatings

Coating Thickness

Series 200 coatings consist of a total surface area build-up, therefore, you must allow for the surface growth (typically between 0.0005 and 0.001 inch) before machining. To ensure dimensional integrity after coating, Endura^® will submit coating thickness values during the design phase, when requested.

Base Metal Surface Requirements

Surface contaminants and imperfections must be removed prior to processing at Endura^® Coatings. Based on the extreme coating uniformity, surface imperfectionin base metal will remain after coating.

Masking

One of the unique advantages of Series 200 coatings is that the entire surface area is coated (i.e. external, internal threaded holes, and through holes), therefore, it is less costly to coat the entire part, and subsequently, reduces processing time factors. In the event masking is required (threaded holes, etc.), it must be clearly noted on your prints or corresponding documentation.

© 2009 Endura^® Coatings All Rights Reserved | Site: Site: Formcode Michigan Web Design

PHONE 586.739.0101 • FAX 586.739.4040

For 40 years, Endura has applied patented and proprietary coatings and licensed coating technology for an array of solutions.
We are not a raw material supplier; nor are the coatings we provide UV stable; nor do we provide any paint, decorative powder coating, or any materials for retail, garage, cement or floor coatings.